Use electrical tape to wrap around each wire cap to create a tight seal and reinsert them back into the junction box and screw the junction box cover back into place.Then pair the wires to the corresponding color using the wire caps attached to the power supply.Insert the power supply with the strain relief into the junction box as shown and secure it with a ring nut.Slide and secure a strain relief onto the power supply. Use a Phillips head screwdriver to remove the screw from the junction box.If a 3 prong wire supply is used it should be an accessible location adjacent to the dishwasher within 4 feet of the dishwasher's side and not behind the unit.The dishwasher should have a dedicated properly grounded circuit to connect the 3 wire setup which includes the ground wire.Connect the water supply line to the inlet valve and use a wrench to tighten firmly.Toward the bottom front of the unit is the inlet valve on the left and the electrical junction box to the right.
Slide the unit further back to reveal the water supply line and power supply.Remove the tape from both the water supply line and power supply and pull both through the dishwasher's bottom openings.Position the unit closely in front of the water supply line and power supply.Toward the bottom of the dishwasher, remove the 2 screws attaching the lower cover and set the cover aside.Remove the rear plastic shipping brace.Unbox and remove any packaging material from the unit.To ensure proper drainage install the dishwasher no farther than 12 feet from the sink and drain lines and do not kink or bend the water supply line and drain hoses.Extend the water supply line and power supply outward and loosely tape both to the floor, approximately 14" to 16" apart.Use a 2 1/2" diameter hole saw to drill a hole in the target areas shown on the template.In case there are no openings on the sides of the cabinet cavity. Use the template included, located on top of the unit and the manual to determine the clearance on the side of the cabinet where the cabinet meets the back wall to feed your water and drain supply line and power cord if needed.
0 kommentar(er)
